Bridge Mode should be used if there is an existing device that is already handling DHCP/NAT on your network. Plume Pods are shipped in Auto Mode by default and if it detects an existing router handling DHCP/NAT, it will self-configure into (Auto) Bridge. If no DHCP is detected, Plume will to switch Router Mode.
IMPORTANT - When Plume is set in Router Only Mode, each hardwired pod acts as a router and DHCP server. Multiple DHCP servers on the same network will cause duplicate IP assignments, leading to network instability and other issues.
Follow these steps to switch Plume back to Auto (Bridge), if the networking mode was set to Router Only.
- Open the main menu by tapping the " Ξ " button on the bottom-left of the App home screen.
- While on the WiFi page, tap Advanced WiFi Setting at the bottom of the page"
- Networking Mode will display Plume's current mode, tap here to change.
- Tap Auto Mode and then OK on the pop-up screen.
- A prompt will tell you that Plume is restarting. It may take up to 90 seconds for your network to come back up.
- Open the main menu by tapping the " Ξ " button on the top-left of the App home screen.
- Tap Advanced Settings
- In your Advanced Settings screen, tap Network Mode
- Tap Auto Mode and a pop-up will warn you that you will need to restart Plume.
- Tap Restart and Plume will reboot. It may take up to 90 seconds for your network to come back up.